偏导射流伺服阀前置级流场特性研究

李竞;延皓;任玉凯;许玲玲;董立静

兵工学报 ›› 2018, Vol. 39 ›› Issue (5) : 1012-1021.

兵工学报 ›› 2018, Vol. 39 ›› Issue (5) : 1012-1021. DOI: 10.3969/j.issn.1000-1093.2018.05.023
论文

偏导射流伺服阀前置级流场特性研究

  • 李竞, 延皓, 任玉凯, 许玲玲, 董立静
作者信息 +

Research on Flow Field in Pre-stage of Jet Deflector Servo Valve

  • LI Jing, YAN Hao, REN Yu-kai, XU Ling-ling, DONG Li-jing
Author information +
文章历史 +

摘要

建立偏导射流伺服阀前置级流场精确且完整的数学模型,对伺服阀先导级设计和研究有着重要作用。将射流过程分为初次射流、偏导板压力恢复、二次射流、接收口压力恢复4个阶段,在前置级二次射流过程中分别采用不同理论模型来构建前置级流场完整的数学模型,对射流形态的演变过程进行了描述。分析发现,油液射流进入前置级流场与偏导板侧壁发生撞击,流动形态发生改变,一部分油液沿侧壁反向流出偏导板,另一部分油液流速降低在下游形成高压区。油液流出偏导板时受到分流器的作用,分别流入不同通道。根据节流模型流量和压力特性公式求得了压力增益,并建立起负载压力与偏导板偏移量之间的数学关系。数值模拟过程中,采用不同湍流模型对前置级流场压力分布进行了分析。通过数值模拟仿真结果、外特性实验结果与射流模型计算结果的比较和分析,验证了该模型描述射流特性的有效性和合理性。

Abstract

A precise and complete mathematical model for the flow field in the pre-stage of jet deflector servo valve is established for the design and research of pilot-stage servo valve. The jet process is divided into four stages: initial jet, deflector pressure recovery, secondary jet, and pressure recovery at receiver opening. In the process of two jets in the pre-stage, the different theoretical models are adopted to build the complete mathematical model of flow field in the pre-stage, and the evolution of jet pattern is described in detail. It is found through analysis that the oil enters the flow field in pre-stage and impacts on the side wall of deflector, and then the flow pattern changes, one part of oil flows out of the deflector along its side wall, the flow velocity of the other part of oil decreases, and a high pressure zone is formed downstream. The oil is affected by the flow divider when it flows out of the deflector, and flows into different channels. The flow and pressure characteristic equations are used to derive the pressure gain, and a mathematic relation between load pressure and deflector offset is established. In the process of numerical simulation, the different turbulence models are adopted to analyze the pressure distribution of flow field in the pre-stage. The effectiveness and rationality of the proposed model describing the jet characteristics is verified by comparing and analyzing the numerically simulated results, the external characteristic experimental results and the calculated results of jet model.Key

关键词

偏导射流伺服阀 / 流场模型 / 紊动射流 / 湍流模型

Key words

jetdeflectorservovalve / flowfieldmodel / turbulentjet / turbulencemodel

引用本文

导出引用
李竞, 延皓, 任玉凯, 许玲玲, 董立静. 偏导射流伺服阀前置级流场特性研究. 兵工学报. 2018, 39(5): 1012-1021 https://doi.org/10.3969/j.issn.1000-1093.2018.05.023
LI Jing, YAN Hao, REN Yu-kai, XU Ling-ling, DONG Li-jing. Research on Flow Field in Pre-stage of Jet Deflector Servo Valve. Acta Armamentarii. 2018, 39(5): 1012-1021 https://doi.org/10.3969/j.issn.1000-1093.2018.05.023

基金

国家自然科学基金项目(51775032);国家国际科技合作项目(2012DFG71490);中央高校基本科研业务专项基金项目(2015JBC022)

参考文献



[1]田源道. 电液伺服阀技术[M]. 北京:航空工业出版社, 2008.
TIAN Yuan-dao. Electrohydraulic servo valve technology[M]. Beijing: Aviation Industry Press, 2008. (in Chinese)
[2]SomashekharS H, Singaperumal M, Kumar R K. Modelling the steady-state analysis of a jet pipe electrohydraulic servo valve[J]. Proceedings of the Institution of Mechanical Engineers. Part I: Journal of Systems & Control Engineering, 2006, 220(2): 109-129.
[3]Pham X H S, Thien-Phuc T. Mathematical model of steady state operation in jet pipe electro-hydraulic servo valve[J]. Journal of Donghua University: English Edition, 2013, 30(4): 269-275.
[4]訚耀保, 张鹏, 张阳.偏转板伺服阀压力特性研究[J]. 流体传动与控制, 2014(4): 10-15.
YIN Yao-bao, ZHANG Peng, ZHANG Yang. Study on pressure characteristics of servo valve of deflector plate[J]. Fluid Power Transmission and Control, 2014(4): 10-15. (in Chinese)
[5]康硕,延皓,李长春.偏转射流式伺服阀研究综述[J].北京交通大学学报,2017,41(1):130-139.
KANG Shuo, YAN Hao, LI Chang-chun. Research review of the deflector jet servo valve[J]. Journal of Beijing Jiaotong University, 2017, 41(1):130-139.(in Chinese)
[6]訚耀保, 张鹏, 岑斌. 偏转板射流伺服阀前置级流场分析[J]. 中国工程机械学报, 2015, 13(1): 1-7.
YIN Yao-bao, ZHANG Peng, CEN Bin. Pre-stage flow field analysison deflector jet servo valves[J]. Chinese Journal of Construction Machinery, 2015, 13(1): 1-7.(in Chinese)
[7]王传礼,丁凡,李其朋,等. 射流盘伺服阀控电液位置系统的动态特性[J]. 重庆大学学报:自然科学版, 2003, 26(11): 11-15.
WANG Chuan-li,DING Fan,LI Qi-peng, et al. Dynamic characteristics of electro-hydraulic position system controlled by jet-pan servovalve[J]. Journal of Chongqing University: Natural Science Edition, 2003, 26(11): 11-15. (in Chinese)
[8]Li Y S. Mathematical modelling and characteristics of the pilot valve applied to a jet-pipe/deflector-jet servovalve[J]. Sensors & Actuators A Physical, 2016, 245: 150-159.
[9]马小良. 偏导射流电液伺服阀工程化建模及仿真研究[J]. 液压与气动, 2015(3): 83-85.
MA Xiao-liang. Model and simulation for deflector jet electrohydraulic servovalve[J]. Chinese Hydraulics & Pneumatics, 2015(3): 83-85.(in Chinese)

[10]SangiahD K, Plummer A R, Bowen C R, et al. A novel piezohydraulic aerospace servovalve. Part 1: design and modelling[J]. Proceedings of the Institution of Mechanical Engineers Part I:Journal of Systems & Control Engineering, 2013, 227(4): 371-389.
[11]延皓,康硕,宋佳,等. 基于仿真离散数据的偏转板射流式伺服阀液动力计算方法研究[J].机械工程学报, 2016, 52(12):181-191.
YAN Hao, KANG Shuo, SONG Jia, et al. Research on the calculation methods of fluid force at prestage of jet deflector servo valve based on the simulated discrete data[J]. Journal of Mechanical Engineering, 2016, 52(12): 181-191. (in Chinese)
[12]蒋大伟,许明理. 基于Fluent的偏转板射流伺服阀的前置级仿真[J].液压与气动, 2016(4): 48-53.
JIANG Da-wei, XU Ming-li. Simulation based on fluent for pre-stage of deflector jet servo valve[J]. Chinese Hydraulics & Pneumatics, 2016 (4): 48-53. (in Chinese)
[13]竹中利夫, 浦田映三. 液压流体力学[M]. 温立中,贺正辉,译. 北京:科学出版社, 1980.
Takenaka Toshio, Urata Eizo. Hydromecjanics[M]. WEN Li-zhong,HE Zheng-hui, translated. Beijing:Science Press, 1980. (in Chinese)
[14]余常昭. 紊动射流[M]. 北京:高等教育出版社, 1993.
YU Chang-zhao. Turbulent jet[M].Beijing:Higher Education Press, 1993. (in Chinese)
[15]Yan H, Wang F J, Li C C, et al. Research on the jet characteristics of the deflector-jet mechanism of the servo valve[J]. Chinese Physics B, 2017, 26(4): 252-260.
[16]Albertson M L, Dai Y B, Jensen R A, et al. Diffusion of submerged jets[J]. American Society of Civil Engineers, 1950, 115(11):639-664.
[17]Bourque C, Newman B G. Reattachment of a two-dimensional, incompressible jet to an adjacent flat plate[J]. Aeronautical Quarterly, 2016, 11(3): 201-232.
[18]延皓,康硕,王凤聚,等. 偏转板射流式伺服阀前置级液动力计算方法研究[J]. 兵工学报, 2016, 37(7): 1258-1265.
YAN Hao, KANG Shuo, WANG Feng-ju, et al. Research on the calculation methods of fluid force in pilot stage of jet deflector servo valve[J]. Acta Armamentarii, 2016, 37(7): 1258-1265. (in Chinese)
[19]Xu J L, Xu Z, Huang S J, et al. Effect of wall function in numerical study on turbulent impinging jet[J]. Transactions of Nanjing University of Aeronautics & Astronautics, 2001, 18(1): 29-34.
[20]郭永怀. 边界层理论讲义[M]. 合肥:中国科学技术大学出版社, 2008.
GUO Yong-huai. Boundary theory[M]. Hefei:University of Science and Technology of China Press, 2008.(in Chinese)






第39卷
第5期2018年5月兵工学报ACTA
ARMAMENTARIIVol.39No.5May2018

291

Accesses

0

Citation

Detail

段落导航
相关文章

/